Last time we outlined how to divide down an FPGAs clock frequency using a basic counter circuit. This allowed us to have varying blinking frequencies for our LEDs depending on which bits of the counter register we tied them to.

What if we needed to adjust for a specific frequency of blinking, of wanted to adjust the time the LED is on vs off? What we are looking for is a programmable square wave generator. I will show you how we can program an FPGA in Verilog to act as one that takes two 4-bit inputs to control the on/off periods of the square wave.

Once we have went through the process of adjusting the on/off timing of a square wave, creating an adjustable PWM output for an LED comes naturally. We will see how to program an FPGA to output a PWM signal that allows us to adjust the brightness of an LED based on a 4 bit input signal.

Continue reading →